Z - pressure transducer

Basic technical information of pressure transmitter

EMC – according to ČSN EN 61326-1
At the customer´s wish it is possible to secure a metrological verification of the transmitters at an accredited Calibration Service Centre.

Instructions for use

• Before connection of the transducer into the pressure circuit, it is necessary to verify that the pressure being measured corresponds to the nominal range of this transducer. Even a transient loading over the maximum allowable overpressure may cause a destruction of the measuring diaphragm!
• Especially by using silicon membrane is necessary to check up resistnace of materials, see the front of this sheet. In case of doubt contact the manufacturer.
• For sealing the transmitter is recommended to use the "O" ring 12x2 supplied with the transmitter. During sealing into the thread (teflon, tow) for fluid medium is necessary take notice of, because during driving screws into a closed volume of fluid can increase pressure and thereby can be the membrane destroyed!

Diagram

Pin assignmentsvalid for connector DIN 43650

	two-wire 4 ÷ 20mA	three-wire 0 ÷ 20mA	three-wire 0 ÷ 10V
+ supply voltage	1	3	3
- supply voltage	2	2	2
output		1	1
shielding

Dimensions of pressure transmitter